6.5 Configuration of the I/O devices
Information on configuring peripheral devices can be found in the "Released PCS 7 Modules"
manual. The components and modules listed in the manual have been tested with PCS 7 and
are supported from the PCS 7 "Generate module drivers" function. These released PCS 7
modules can be selected within the hardware configuration catalog from the "PCS 7 V8.1"
profile.
6.5.1 ET 200M as DP slave (H system and standard AS)
Introduction
The following describes the configuration of an ET 200M station as a typical DP slave. The
name of the DP slave should be based on the naming conventions for a plant or plant network
to allow you to quickly locate faults in case of servicing.
Note
The exact step-by-step description for configuring an ET 200M station can be found in the
"SIMATIC Process Control System PCS 7 Engineering System" (https://
support.industry.siemens.com/cs/ww/en/view/109485969) manual.
Example: 2550C01CA04
25: Short designation of the production facility
50: Name of the control room
C01C: Name and position of the rack
A04: Module slot
If an error occurs in the DP subnet, a message containing information about the position of
the faulty slave is generated on the OS.
Configuration of the hardware (AS and I/O)
6.5 Configuration of the I/O devices
Compendium Part A - Configuration Guidelines (V8.2)
Configuration Manual, 08/2016, A5E38166869-AA 113
To Next Page
Loading...
