Parameter Description Factory settings
p0854[C] BI: Master control by PLC/no control by PLC Dependent on the
converter
p1036[C] BI: Motorized potentiometer setpoint lower 0
p1055[C] BI: Jogging bit 0 0
r2090[0 … 15] BO: PROFIdrive receive PZD1 bit by bit -
p2103[C] BI: 1. Acknowledge faults Dependent on the
converter
Advanced commissioning
8.11 Switching over the drive control (command data set)
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 229
To Next Page
Loading...
