Siemens SINAMICS G110M - Page 83

-RJ
-RJ
&RQWURODQG6HWSRLQW
)LHOGEXV
-RJ
)LHOGEXVLVQRWDFWLYH
&RQWUROYLD352),GULYH7HOHJUDPP
1R)XQFWLRQ
1R)XQFWLRQ
$FNQRZOHGJHIDXOW
$ODUP
)DXOW
', 
', 
', 
', 
', 
', 
', 
', 
;
;
;
;
',
',
',
'2
'2
',
Figure 4-17 Macro 7 - Switch over between 󹪝eldbus and jogging using DI 3 (default DP/PN)
&RQWUROYLD$6L6LQJOH6ODYH
5HDG\YLD3/&
21)L[HG
6SHHG
VHWSRLQW
2))
2))RU
DFNQRZ
OHGJHIDXOW
0RWRULVUXQQLQJ
)DXOWRU:DUQLQJFRGH
5HTXHVW)DXOWDQG$ODUPFRGH
7UDQVPLW
'DWD
5HFHLYH
'DWD
',
',
;
;
$6L',
$6L',
$6L'2






$6L'2

$6L3
$6L',
$6L',
$6L35

$6L35
Figure 4-18 Macro 30 - ASi Single slave with 󹪝xed setpoints (default ASi)
Note
Unswitched and switched power supply
The unswitched 24 V power supply (also known as non-switched) on X1.2 and X1.4 provides
power to the general electronics of the Control Unit. The switched 24 V power supply on X1.1
and X1.5 supplies power for the two digital outputs (DI0 and DI1).
For a complete explanation of the unswitched and switched 24 V supplies and their limitations,
please read the FAQ at the following link:
Unswitched and switched 24 V supply (http://support.automation.siemens.com/WW/view/
en/26986267)
Installation
4.3 Electrical Installation
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 81