Default settings for the CU240M
The default settings that are available for the CU240M Control Modules are shown in the gures
below. Default settings 7 is the default setting for the CU240M DP and CU240M PN Control
Modules, default settings 21 is the default settings for the CU240M USS Control Module and
default settings 30 is the default settings for the CU240M ASi Control Modules.
-RJ
-RJ
&RQWURODQG6HWSRLQW
)LHOGEXV
-RJ
)LHOGEXVLVQRWDFWLYH
&RQWUROYLD352),GULYH7HOHJUDPP
1R)XQFWLRQ
1R)XQFWLRQ
$FNQRZOHGJHIDXOW
$ODUP
)DXOW
',
',
',
',
',
',
',
',
;
;
;
;
',
',
',
'2
'2
',
Figure 4-19 Default settings 7 - Switch over between eldbus and jogging using DI 3 (default DP/PN)
0RWRUSRWHQWLRPHWHUGHFUHDVH
212))
0RWRUSRWHQWLRPHWHULQFUHDVHG
$FNQRZOHGJHIDXOW
$ODUP
)DXOW
',
',
',
',
;
;
;
'2
'2
Figure 4-20 Default settings 9 - Motorized potentiometer (MOP)
6SHHGVHWSRLQW
212))
5HYHUVH
$FNQRZOHGJHIDXOWV
$ODUP
)DXOW
$,
;
',
',
',
;
;
;
'2
'2
Figure 4-21 Default settings 12 - Two-wire control with method 1
Installation
4.3 Electrical Installation
Distributed converter for SIMOGEAR geared motors
82 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
To Next Page
Loading...
