6.2.44 EXPANSION MULTIFUNCTIONAL OUTPUT TERMINAL.....................................
6.2.45 SERVOCONTROL AND SCALE POSITIONING......................................................
6.2.46 VIRTUAL INPUT AND OUTPUT...................................................................................
6.2.47 PROTECTION FUNCTION CONFIGURATION PARAMETER.............................
6.2.48 CORRECTION PARAMETER.......................................................................................
6.2.49 SPECIAL FUNCTIONAL PARAMETERS...................................................................
6.2.50 OTHER CONFIGURATION PARAMETERS..............................................................
6.2.51 HISTORICAL FAULT RECORDING............................................................................
6.2.52 OPERATION STATUS AT THE LAST FAULT............................................................
6.2.53 BASIC STATUS PARAMETER.....................................................................................
6.2.54 AUXILIARY STATUS PARAMETER............................................................................
6.2.55 MODBUS FIELDBUS STATUS PARAMETER (Standard Expansion Card)......
6.2.56 TERMINAL STATUS AND VARIABLE.........................................................................
6.2.57 COUNTER TIMER VALUE............................................................................................
6.2.58 SPINDLE CONTROL AND SCALE POSITIONING STATUS PARAMETER......
6.2.59 EQUIPMENT INFORMATION.......................................................................................
7. DESCRIPTION OF SPECIFIC FUNCTIONS...............................................................................
7.1 SYSTEM MANAGEMENT (GROUP F0.0)....................................................................................
7.2 RUNNING COMMAND SELECTION (GROUP F0.1).................................................................
7.3 FREQUENCY SETUP (GROUP F0.2)........................................................................................
7.4 CONTROL COMMAND SOURCE (GROUP F0.3)...................................................................
7.5 START AND STOP (GROUP F0.4)..............................................................................................
7.6 ACCEL AND DECEL CHARACTERISTICS (GROUP F1.0)...................................................
7.7 CARRIER FREQUENCY (GROUP F1.1)...................................................................................
7.8 V/F PARAMETERS AND OVERLOAD PROTECTION (MOTOR 1) (GROUP F1.2)........
7.9 V/F PARAMETERS AND OVERLOAD PROTECTION (MOTOR 2) (GROUP F1.3)........
7.10 STEADY RUNNING (GROUP F1.4)..........................................................................................
7.11 VECTOR RUNNING PARAMETERS (MOTOR 1) (GROUP F2.0).....................................
7.12 PARAMETER MEASUREMENT AND PRE-EXCITATION (GROUP F2.2).......................
7.13 MULTIFUNCTIONAL INPUT TERMINAL (GROUP F3.0).....................................................
7.14 MULTIFUNCTIONAL OUTPUT TERMINAL (GROUP F3.1)................................................
7.15 PULSE INPUT (GROUP F3.2)...................................................................................................
7.16 PULSE OUTPUT (GROUP F3.3)...............................................................................................
7.17 ANALOG INPUT (GROUP F4.0)................................................................................................
7.18 ANALOG INPUT CURVE CORRECTION (GROUP F4.1)...................................................
7.19 ANALOG OUTPUT (GROUP F4.2)...........................................................................................
80
80
82
84
85
85
86
87
87
88
90
90
91
91
92
92
97
97
105
111
114
116
123
125
126
128
128
132
133
134
142
145
146
147
148
148
To Next Page
Loading...
