P
ORT
C
ONFIGURATION
3-95
Statically Configuring a Trunk
Command Usage
• When configuring static trunks, you
may not be able to link switches of
different types, depending on the
manufacturer’s implementation.
However, note that the static trunks
on this switch are Cisco
EtherChannel compatible.
• To avoid creating a loop in the
network, be sure you add a static
trunk via the configuration interface
before connecting the ports, and also disconnect the ports before
removing a static trunk via the configuration interface.
Command Attributes
• Member List (Current) – Shows configured trunks (Trunk ID, Unit,
Port).
• New – Includes entry fields for creating new trunks.
- Trunk
– Trunk identifier. (Range: 1-4)
-
Unit
– Stack unit. (Range: 1-8)
-
Port
– Port identifier. (Range: 1-26)
active
links
}
statically
configured
To Next Page
Loading...
Need help?
General
