C
LASS
OF
S
ERVICE
C
ONFIGURATION
3-171
Command Attributes
• Priority – CoS value. (Range: 0-7, where 7 is the highest priority)
• Traffic Class
10
– Output queue buffer. (Range: 0-3, where 3 is the
highest CoS priority queue)
Web – Click Priority, Traffic Classes. Assign priorities to the traffic classes
(i.e., output queues), then click Apply.
Figure 3-73 Traffic Classes
CLI – The following example shows how to change the CoS assignments
to a one-to-one mapping.
Note: Mapping specific values for CoS priorities is implemented as an
interface configuration command, but any changes will apply to
the all interfaces on the switch.
10. CLI shows Queue ID.
Console(config)#interface ethernet 1/1 4-146
Console(config-if)#queue cos-map 0 0 4-226
Console(config-if)#queue cos-map 1 1
Console(config-if)#queue cos-map 2 2
Console(config-if)#end
Console#show queue cos-map ethernet 1/1 4-228
Information of Eth 1/1
CoS Value : 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 1 2 2 3 3
Console#
To Next Page
Loading...
Need help?
General
