C
ONFIGURING
THE
S
WITCH
3-26
Downloading Configuration Settings from a Server
You can download the configuration file under a new file name and then
set it as the startup file, or you can specify the current startup
configuration file as the destination file to directly replace it. Note that the
file “Factory_Default_Config.cfg” can be copied to the TFTP server, but
cannot be used as the destination on the switch.
Web – Click System, File, Copy. Select “tftp to startup-config” or “tftp to
file” and enter the IP address of the TFTP server. Specify the name of the
file to download and select a file on the switch to overwrite or specify a
new file name, then click Apply.
Figure 3-11 Copy Configuration Settings
To Next Page
Loading...
