SMC Networks TigerSwitch

A CCESS C ONTROL L IST C OMMANDS
4-135
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must configure an ACL mask before you can map CoS values to
the rule.
• A packet matching a rule within the specified ACL is mapped to one
of the output queues as shown below.
Example
Related Commands
queue cos-map (4-226)
show map access-list mac (4-135)
show map access-list mac
This command shows the CoS value mapped to a MAC ACL for the
current interface. (The CoS value determines the output queue for packets
matching an ACL rule.)
Syntax
show map access-list mac [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
Table 4-37 Egress Queue Priority Mapping
Queue 0123
Priority
1,2 0,3 4,5 6,7
Console(config)#int eth 1/5
Console(config-if)#map access-list mac M5 cos 0
Console(config-if)#