SMC Networks TigerSwitch

C OMMAND L INE I NTERFACE
4-94
whichboot
This command displays which files were booted when the system powered
up.
Syntax
whichboot [unit]
unit - Specifies the unit number.
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot
command. See the table under the dir command for a description of the
file information displayed by this command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
- boot-rom* - Boot ROM.
- config* - Configuration file.
- opcode* - Run-time operation code.
- filename - Name of the configuration file or image name.
Console#whichboot
file name file type startup size (byte)
----------------- -------------- ------- -----------
Unit1:
YAD2212.bix Boot-Rom image Y 169908
V2253 Operation Code Y 1741464
Factory_Default_Config.cfg Config File Y 5013
Console#