F
LASH
/F
ILE
C
OMMANDS
4-93
- boot-rom - Boot ROM (or diagnostic) image file.
- config - Switch configuration file.
- opcode - Run-time operation code image file.
- filename - Name of the configuration file or image name.
- unit - Stack unit. (Range: 1-8)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• If you enter the command dir without any parameters, the system
displays all files.
• A colon (:) is required after the specified unit number.
• File information is shown below:
Example
The following example shows how to display all file information:
Table 4-26 File Directory Information
Column Heading Description
file name The name of the file.
file type File types: Boot-Rom, Operation Code, and Config file.
startup Shows if this file is used when the system is started.
size The length of the file in bytes.
Console#dir 1:
file name file type startup size (byte)
---------------------------- -------------- ------- -----------
Unit1:
DIAG_0.0.0.4.BIX Boot-Rom image Y 169900
LEO_50Y_V0.0.5.1.bix Operation Code Y 1614764
Factory_Default_Config.cfg Config File N 5013
startup Config File Y 3191
-------------------------------------------------------------------
Total free space: 5242880
Console#
To Next Page
Loading...
Need help?
General
