SMC Networks TigerSwitch

S YSTEM M ANAGEMENT C OMMANDS
4-63
logging trap
This command enables the logging of system messages to a remote server,
or limits the syslog messages saved to a remote server based on severity.
Use this command without a specified level to enable remote logging. Use
the no form to disable remote logging.
Syntax
logging trap [level]
no logging trap
level - One of the level arguments listed below. Messages sent
include the selected level up through level 0. (Refer to the table on
page 4-60.)
Default Setting
• Enabled
•Level 7 - 0
Command Mode
Global Configuration
Command Usage
• Using this command with a specified level enables remote logging and
sets the minimum severity level to be saved.
• Using this command without a specified level also enables remote
logging, but restores the minimum severity level to the default.
Example
Console(config)#logging trap 4
Console(config)#