C
OMMAND
L
INE
I
NTERFACE
4-112
dot1x operation-mode
This command allows single or multiple hosts (clients) to connect to an
802.1X-authorized port. Use the no form with no keywords to restore the
default to single host. Use the no form with the multi-host max-count
keywords to restore the default maximum count.
Syntax
dot1x operation-mode {single-host | multi-host [max-count
count]}
no dot1x operation-mode [multi-host max-count]
• single-host – Allows only a single host to connect to this port.
• multi-host – Allows multiple host to connect to this port.
• max-count – Keyword for the maximum number of hosts.
- count – The maximum number of hosts that can connect to a port.
(Range: 1-20; Default: 5)
Default
Single-host
Command Mode
Interface Configuration
Command Usage
• The “max-count” parameter specified by this command is only
effective if the dot1x mode is set to “auto” by the dot1x port-control
command (page 4-111).
• In “multi-host” mode, only one host connected to a port needs to pass
authentication for all other hosts to be granted network access.
Similarly, a port can become unauthorized for all hosts if one attached
host fails re-authentication or sends an EAPOL logoff message.
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x operation-mode multi-host max-count 10
Console(config-if)#
To Next Page
Loading...
Need help?
General
