SMC Networks TigerSwitch

R ATE L IMIT C OMMANDS
4-163
• fastethernet – Fast Ethernet granularity
• gigabitethernet – Gigabit Ethernet granularity
• granularity – Sets rate limit granularity for the system. For Fast
Ethernet, choose 512 Kbps, 1 Mbps, or 3.3 Mbps. For Gigabit
Ethernet, only one granularity option is supported, 33.3 Mbps
Default Setting
Fast Ethernet interface – 3.3 Mbps
Gigabit Ethernet interface – 33.3 Mbps
Command Mode
Global Configuration (Ethernet, Port Channel)
Command Usage
Actual rate limit = Rate limit level * Granularity
Example
The following sets Fast Ethernet granularity to 1 Mbps, and Gigabit
Ethernet granularity to 33.3 Mbps.
show rate-limit
Use this command to display the rate limit granularity.
Default Setting
Fast Ethernet interface – 3.3 Mbps
Gigabit Ethernet interface – 33.3 Mbps
Command Mode
Privileged Exec
Command Usage
• For Fast Ethernet interfaces, the rate limit granularity is 512 Kbps, 1
Mbps, or 3.3 Mbps.
• For Gigabit Ethernet interfaces, the rate limit granularity is 33.3 Mbps.
Console(config)#rate-limit fastethernet granularity 1000
Console(config)#rate-limit gigabitethernet granularity 33300
Console(config)#