C
ONFIGURING
THE
S
WITCH
3-186
Notes: 1. All systems on the subnet must support the same version.
2. Some attributes are only enabled for IGMPv2, including
IGMP Report Delay and IGMP Query Timeout.
Web – Click IGMP Snooping, IGMP Configuration. Adjust the IGMP
settings as required, and then click Apply. (The default settings are shown
below.)
Figure 3-82 IGMP Configuration
CLI – This example modifies the settings for multicast filtering, and then
displays the current status.
Console(config)#ip igmp snooping 4-239
Console(config)#ip igmp snooping querier 4-243
Console(config)#ip igmp snooping query-count 10 4-243
Console(config)#ip igmp snooping query-interval 100 4-244
Console(config)#ip igmp snooping query-max-response-time 20 4-245
Console(config)#ip igmp snooping query-time-out 300 4-246
Console(config)#ip igmp snooping version 2 4-240
Console(config)#exit
Console#show ip igmp snooping 4-241
Service status : Enabled
Querier status : Enabled
Query count : 10
Query interval : 100 sec
Query max response time : 20 sec
Router port expire time : 300 sec
IGMP snooping version : Version 2
Console#
To Next Page
Loading...
Need help?
General
