C
OMMAND
L
INE
I
NTERFACE
4-130
MAC ACLs
access-list mac
This command adds a MAC access list and enters MAC ACL configuration
mode. Use the no form to remove the specified ACL.
Syntax
[no] access-list mac acl_name
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Table 4-36 MAC ACLs
Command Function Mode Page
access-list mac Creates a MAC ACL and enters
configuration mode
GC 4-130
permit, deny Filters packets matching a specified
source and destination address, packet
format, and Ethernet type
MAC-ACL 4-131
show mac
access-list
Displays the rules for configured MAC
ACLs
PE 4-133
mac access-group Adds a port to a MAC ACL IC 4-133
show mac
access-group
Shows port assignments for MAC ACLs PE 4-134
map access-list
mac
Sets the CoS value and corresponding
output queue for packets matching an
ACL rule
IC 4-134
show map
access-list mac
Shows CoS value mapped to an access
list for an interface
PE 4-135
To Next Page
Need help?
General
