SMC Networks TigerSwitch

C OMMAND L INE I NTERFACE
4-116
Command Mode
Privileged Exec
Command Usage
This command displays the following information:
• Global 802.1X Parameters – Shows whether or not 802.1X port
authentication is globally enabled on the switch.
• 802.1X Port Summary – Displays the port access control parameters
for each interface, including the following items:
- Status – Administrative state for port access control.
- Operation Mode– Dot1x port control operation mode (page
4-112).
- Mode – Dot1x port control mode (page 4-111).
- Authorized – Authorization status (yes or n/a - not authorized).
• 802.1X Port Details – Displays the port access control parameters
for each interface, including the following items:
- reauth-enabled – Periodic re-authentication (page 4-113).
- reauth-period – Time after which a connected client must be
re-authenticated (page 4-114).
- quiet-period – Time a port waits after Max Request Count is
exceeded before attempting to acquire a new
client (page 4-114).
- tx-period – Time a port waits during authentication session
before re-transmitting EAP packet (page
4-115).
- supplicant-timeout– Supplicant timeout.
- server-timeout – Server timeout.
- reauth-max – Maximum number of reauthentication
attempts.
- max-req – Maximum number of times a port will
retransmit an EAP request/identity packet to
the client before it times out the authentication
session (page 4-110).
- Status – Authorization status (authorized or not).
- Operation Mode– Shows if single or multiple hosts (clients) can
connect to an 802.1X-authorized port.