C
OMMAND
L
INE
I
NTERFACE
4-220
Default Setting
• join: 20 centiseconds
• leave: 60 centiseconds
• leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Group Address Registration Protocol is used by GVRP and GMRP to
register or deregister client attributes for client services within a
bridged LAN. The default values for the GARP timers are
independent of the media access method or data rate. These values
should not be changed unless you are experiencing difficulties with
GMRP or GVRP registration/deregistration.
• Timer values are applied to GVRP for all the ports on all VLANs.
• Timer values must meet the following restrictions:
- leave >= (2 x join)
- leaveall > leave
Note: Set GVRP timers on all Layer 2 devices connected in the same
network to the same values. Otherwise, GVRP may not operate
successfully.
Example
Related Commands
show garp timer (4 -221)
Console(config)#interface ethernet 1/1
Console(config-if)#garp timer join 100
Console(config-if)#
To Next Page
Loading...
