SMC Networks TigerSwitch

P RIORITY C OMMANDS
4-235
show map ip port
Use this command to show the IP port priority map.
Syntax
show map ip port [interface]
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26)
• port-channel channel-id (Range: 1-4)
Default Setting
None
Command Mode
Privileged Exec
Example
The following shows that HTTP traffic has been mapped to CoS value 0:
Related Commands
map ip port (Global Configuration) (4 -229)
map ip port (Interface Configuration) (4 -230)
Console#show map ip port
TCP port mapping status: enabled
Port Port no. COS
--------- -------- ---
Eth 1/ 5 80 0
Console#