Operation 5
Commissioning
0
I
1
– Insert switch key (1) into the key switch and
turn to position "I".
This initiates a self-test. All symbols on the
display and operating unit are displayed
briefly until the truck controllers have started
up completely.
When the truck is switched on
,thefork
carriage and the reach carri
age must initially
be in the basic position. In t
he basic position,
the fork carriage is fully lo
wered, and the reach
carriage is fully retracted
. This ensures that
the electronic support syst
ems which prevent
the truck from tipping over w
ith a raised load
are recalibrated.
– If the lifting forks and the reach carriage are
not in the basic position when the truck is
switched on, fully lower the load once and
fully retract the reach carriage.
NOTE
The switch key, FleetM
anager card (variant),
FleetManager transpo
nder chip (variant) or
FleetManager PIN code
(variant) must not be
passed to others unles
s explicit instructions to
this effect have been g
iven.
50
988078001 [EN] 71
To Next Page
Loading...
