S CLASS™ cutter User’s Manual
Setup 1-16
The security menu will appear on screen.
11. Use or to choose the correct security method.
The chosen security method (inverse) will change.
12. Press to confirm.
The WLAN menu will appear on screen.
13. Press .
The Configure menu will appear on screen.
14. Use or to go to key 1.
‘ key 1’ will become inverse.
15. Press to enter the password.
A mobile phone like keypad will appear on screen .
16. Enter the password. If there are already asterix’s visible in the top line, then clear them
first by pressing until they are all gone.
The password will appear on screen .
17. Press three times, then press .
The cutter will prompt the user to reboot the machine.
18. Do so.
After a reboot the cutter will show the assigned IP address on the bottom line of the screen.
This address is has to be used when installing the cutter in the cutting software.
Alternate procedure when the access point is not broadcasting:
The procedure is analogue to the procedure above.
Steps 6 -> 8 need to be left out.
After that the password is entered, enter the SSID in the same way as ‘key 1’ was entered.
Alternate procedure when there is no DCHP server:
In this case an IP address and subnet mask needs to be provided by the network
administrator.
The procedure is analogue to the procedure above.
Stop before step 16.
Then continue with procedure below:
To Next Page
Loading...
