Sun Microsystems Netra T5220 - Page 177

Index-5
board, 2-13
installing, 5-24
removing, 5-22
replacing, 5-22
cords
disconnecting, 2-5
supply, 2-13
hot-swapping, 5-3
installing, 5-6
LEDs, 1-12
Fault, 1-13, 5-4
Power OK, 1-13
removing, 5-4
replacing, 5-3
power supply
status, displaying, 1-23
powercycle command, 1-20, 1-32
powering off the system, 2-4
poweroff command, 1-20, 2-4
poweron command, 1-20, 4-29
power-on self-test (POST), 1-5
about, 1-27
ALOM CMT commands, 1-27
components disabled by, 1-43
configuration flowchart, 1-29
controlling output, 1-27
error messages, 1-34
fault clearing, 1-35
faults detected by, 1-21
faulty components detected by, 1-35
parameters, changing, 1-30
reasons to run, 1-31
running in maximum mode, 1-31
troubleshooting with, 1-6
Predictive Self-Healing (PSH)
about, 1-37
clearing faults, 1-40
faults displayed by ILOM, 1-21
memory faults, and, 1-7
procedures for
finishing up, 6-1
parts replacement, 2-3
product notes, 1-52
PS0/PS1 (power supply FRU names), 2-13
PSH
see Predictive Self-Healing (PSH)
Q
quick visual notification, 1-2
R
rear panel
LEDs, 1-10
removefru command, 1-20, 5-5
removing
alarm board, 5-15
antistatic measures, 6-4
battery, 4-30
DIMM/CPU duct, 4-17
fan assembly, 5-7
hard drive, 3-2
hard drive fan assembly, 5-10
LED board, 5-17
NVRAM, 4-32
optical media drive, 3-6
PCI tray, 2-9
PCIe card, 4-11, 4-12
PCI-X card, 4-5, 4-9
power
board, 5-22
supply, 5-4
SCC module, 4-35
server from rack, 2-5
top cover, 2-8
replacing
air filter, 5-1
alarm board, 5-15
battery, 4-30
DIMM/CPU duct, 4-17
fan assembly, 5-6
hard drive, 3-1
hard drive fan assembly, 5-9
LED board, 5-17
motherboard assembly, 4-36
NVRAM, 4-32
optical media drive, 3-6
PCIe card, 4-11
PCI-X card, 4-5
power
board, 5-22
supply, 5-3
reset command, 1-20
resetsc command, 1-20