Sun Microsystems Netra T5220 - Running ALOM CMT CLI Service-Related Commands; Connecting to ALOM CMT CLI

1-18 Sun Netra T5220 Server Service Manual • January 2012
3. Log out of the root account after you have finished creating the new account.
4. Log in to the ALOM CMT CLI (indicated by the sc> prompt) from the ILOM
login prompt.
Note – Multiple service processor accounts can be active concurrently. A user can be
logged in under one account using the ILOM CLI, and another account using the
ALOM CMT CLI.
1.4.3 Running ALOM CMT CLI Service-Related
Commands
This section describes commands commonly used for service-related activities.
1.4.3.1 Connecting to ALOM CMT CLI
Before you can run ALOM CMT CLI commands, you must connect to the service
processor in one of two ways:
■ Connect an ASCII terminal directly to the serial management port.
■ Use the ssh command to connect to the service processor through an Ethernet
connection on the network management port.
-> exit
SUNSPxxxxxxxxxxxx login: admin
Password:
Waiting for daemons to initialize...
Daemons ready
Sun(TM) Integrated Lights Out Manager
Version 2.0.0.0
Copyright 2008 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
sc>