Sun Microsystems Netra T5220 - Displaying System Components

1-44 Sun Netra T5220 Server Service Manual • January 2012
Note – A reset or power cycle is required after disabling or enabling a component. If
the status of a component is changed, there is no effect to the system until the next
reset or power cycle.
1.8.1 Displaying System Components
The showcomponent command displays the system components (asrkeys) and
reports their status.
● At the sc> prompt, enter the showcomponent command
EXAMPLE 1-12 shows partial output with no disabled components.
EXAMPLE 1-12 Output of the showcomponent Command With No Disabled Components
sc> showcomponent
Keys:
/SYS/MB/RISER0/XAUI0
/SYS/MB/RISER0/PCIE0
/SYS/MB/RISER0/PCIE3
/SYS/MB/RISER1/XAUI1
/SYS/MB/RISER1/PCIE1
/SYS/MB/RISER1/PCIE4
/SYS/MB/RISER2/PCIE2
/SYS/MB/RISER2/PCIE5
/SYS/MB/GBE0
/SYS/MB/GBE1
/SYS/MB/PCIE
/SYS/MB/PCIE-IO/USB
/SYS/MB/SASHBA
/SYS/MB/CMP0/NIU0
/SYS/MB/CMP0/NIU1
/SYS/MB/CMP0/MCU0
/SYS/MB/CMP0/MCU1
/SYS/MB/CMP0/MCU2
/SYS/MB/CMP0/MCU3