Sun Microsystems Netra T5220 - Enabling Disabled Components; Exercising the System with Sunvts Software; Checking Whether Sunvts Software Is Installed

1-46 Sun Netra T5220 Server Service Manual • January 2012
2. After receiving confirmation that the disablecomponent command is
complete, reset the server so that the ASR command takes effect.
1.8.3 Enabling Disabled Components
The enablecomponent command enables a disabled component by removing it
from the ASR blacklist.
1. At the sc> prompt, enter the enablecomponent command.
2. After receiving confirmation that the enablecomponent command is complete,
reset the server for so that the ASR command takes effect.
1.9 Exercising the System With SunVTS
Software
Sometimes a server exhibits a problem that cannot be isolated definitively to a
particular hardware or software component. In such cases, it might be useful to run a
diagnostic tool that stresses the system by continuously running a comprehensive
battery of tests. Sun provides the SunVTS software for this purpose.
This section describes the tasks necessary to use SunVTS software to exercise your
server:
■ Section 1.9.1, “Checking Whether SunVTS Software Is Installed” on page 1-46
■ Section 1.9.2, “Exercising the System Using SunVTS Software” on page 1-47
1.9.1 Checking Whether SunVTS Software Is Installed
This procedure assumes that the Solaris OS is running on the server, and that you
have access to the Solaris command line.
sc> reset
sc> enablecomponent /SYS/MB/CMP0/BR1/CH0/D0
Chassis | major: /SYS/MB/CMP0/BR1/CH0/D0 has been enabled.
sc> reset