Sun Microsystems SUN BLADE 150 - Page 214

Index-2 Sun Blade 150 Service Manual • June 2002
D
default console, setting, D–2
default NVRAM settings, displaying, 3–28
defaults
saving OpenBoot PROM settings, 4–17
description
functional, D–1
SunVTS, 2–1
system, 1–1
diag-level
set off, 3–27
set to min, 3–18
diag-level settings, 3–2
diag-level, set to max, 3–6
diagnostic tests
with Sun VTS, 2–1
diagnostics
OpenBoot PROM, 4–5
probe-IDE, 4–7
watch-net-all, 4–6
diagnostics, POST, 3–1
diag-switch
set false, 3–27
diag-switch?
set true, 3–2
DIMM
addresses, 4–5
addressing, C–22
physical memory address, C–22
POST error message, 3–25
removal, 8–7
troubleshooting, 4–5
DIMM, addresses, 4–5
disabling power management, D–1
diskette drive
controller protocols, C–8
data cable assembly, 6–4
data cable removal, 6–3
power cable removal, 6–5
removal, 7–1
display
setting default console, D–2
DVD-ROM
address, 4–3
identifying model, 4–7
jumper settings, A–5
probe IDE diagnostic, 4–7
DVD-ROM drive
removal, 7–11
E
electrical specifications, A–2
electrostatic discharge and safety, 5–3
Energy Star
compliance and specifications, C–25
Energy Star descriptions, C–25
environmental requirements, A–3
error reporting, POST, 3–25
ethernet
cable compatibility, B–7
connector signal descriptions, B–6
PCIO-2 ASIC functional description, C–10
ethernet diagnostics, 4–6
ethernet LED
motherboard diagram, C–3
F
failure
power-on, 4–1
fan assembly
removal, 6–15
fan, CPU
removal, 8–1
fault isolation, POST, 3–28
firewire
functional description, C–11
flash PROM
functional description, C–11
jumper settings, 8–15
floppy drive
controller protocols, C–8
functional description, D–1
functional description, system, C–1
G
graphics
ASIC descriptions, C–10
setting default display, D–2
graphics accelerator
maximum power consumption, 8–11
removing and replacing, 8–10
graphics, default display, D–2
grounding ring
removal, 8–1