Sun Oracle Sun Server X4-2 - Access BIOS Setup Utility Menus

164 Sun Server X4-2 Service Manual • May 2014
Related Information
■ “Access BIOS Setup Utility Menus” on page 164
■ “Navigate BIOS Setup Utility Menus” on page 165
▼ Access BIOS Setup Utility Menus
You can access the BIOS Setup Utility screens from the following interfaces:
■ Use a USB keyboard and VGA monitor connected directly to the server. (A mouse
is not required to access the BIOS Setup Utility.)
■ Use a terminal (or terminal emulator connected to a computer) through the serial
port on the back panel of the server.
■ Connect to the server using the Oracle ILOM Remote Console application.
1. Reset or power on the server.
For example, to reset the server:
■ From the local server, press the Power button on the front panel of the server to
power off the server, and then press the Power button again to power on the
server.
■ From the Oracle ILOM web interface, click Host Management > Power
Control and select Reset from the Select Action list.
■ From the Oracle ILOM CLI on the server SP, type reset /System
The power-on self-test (POST) sequence begins.
F9 Ctrl+O Launch Oracle System Assistant.
BIOS boots to Oracle System
Assistant, bypassing the current
Boot Options Priority list for this
one-time boot method.
Activate Load Optimal Values
pop-up menu. (Not applicable
to UEFI Driver Control menu)
F10 Ctrl+S Not applicable Activate Save and Exit pop-up
menu. (Not applicable to UEFI
Driver Control menu)
F12 Ctrl+N Activate Network boot. Not applicable
TABLE: Function Key to Control Key Sequence Mapping (Continued)
Function
Key
Control Key
Sequence BIOS POST Function BIOS Setup Function