Servicing CRUs That Require Server Power-Off 91
4. Install the PCIe riser.
For instructions, see “Install a PCIe Riser Into PCIe Slots 3 and 4” on page 82.
Servicing the DVD Drive (CRU)
Note – The DVD drive is only available in the four-drive systems.
The DVD drive is accessible from the front panel of the system.
Caution – These procedures require that you handle components that are sensitive
to electrostatic discharge. This sensitivity can cause the components to fail. To avoid
damage, ensure that you follow antistatic practices as described in “Take Antistatic
Measures” on page 42.
Caution – Ensure that all power is removed from the server before removing or
installing the DVD drive or damage to the drive might occur. You must disconnect all
power cables from the system before performing these procedures.
The following procedures are provided in this section:
■ “Remove the DVD Drive” on page 91.
■ “Install the DVD Drive” on page 93.
Related Information
■ “Disconnect Cables From the Server” on page 39
■ “Extend the Server to the Maintenance Position” on page 39
■ “Open the Server Fan Door” on page 43
▼ Remove the DVD Drive
1. Remove any media from the DVD drive.
2. Prepare the server for service.
To Next Page
Loading...
