Servicing CRUs That Do Not Require Server Power-Off 49
4. On the drive you plan to remove, push the latch release button to open the drive
latch.
FIGURE: Locating the Hard Disk Drive Release Button and Latch
Caution – The latch is not an ejector. Do not open the latch too far to the right.
Doing so can damage the latch.
5. Grasp the latch and pull the drive out of the drive slot.
6. Consider your next steps:
■ If you are replacing the drive, continue to “Install a Storage Drive” on page 49.
■ If you are not replacing the drive, install a filler panel in the empty drive slot to
maintain proper airflow and perform administrative tasks to configure the
server to operate without the drive.
Related Information
■ “Storage Drive Status Indicators” on page 47
■ “Storage Drives Hot-Plug Conditions” on page 46
■ “HDD or SSD Failure and RAID” on page 46
■ “Install a Storage Drive” on page 49
▼ Install a Storage Drive
1. Remove the replacement drive from its packaging and place the drive on an
antistatic mat.
To Next Page
Loading...
