143
Returning the Server to Operation
After replacing components inside of the server, perform the procedures in the
following sections.
Removing and Installing Server Filler
Panels
Each server might be shipped with module-replacement filler panels for storage
drives and PCIe cards. These filler panels are installed at the factory and must remain
in the server until you replace them with a purchased option.
Before you can install an optional server component into the server, you must
remove the filler panel from the location into which you intend to install the
component. When you remove a storage drive or a PCIe card from the server, you
must install either a replacement component or a filler panel.
Description Links
Learn about filler panels. “Removing and Installing Server Filler
Panels” on page 143
Install the server top cover. “Install the Server Top Cover” on page 145
Remove antistatic measures. “Remove Antistatic Measures” on page 146
Install the server chassis into the rack. “Reinstall the Server Chassis Into the Rack”
on page 146
Return the server to the normal rack
position.
“Return the Server to the Normal Rack
Position” on page 148
Reconnecting data cables and power cords. “Reconnect Data Cables and Power Cords” on
page 149
Power on the server. “Power On the Server” on page 150
To Next Page
Loading...
