Servicing CRUs That Require Server Power-Off 93
5. To disengage the DVD drive from the chassis, press and hold the release tab on
the rear of the DVD drive up slightly [3].
6. Gently push the DVD drive toward the front of the server, slide it out of the
server, and place it on an antistatic mat [4].
7. Place the DVD drive on an antistatic mat.
Related Information
■ “Install the DVD Drive” on page 93
▼ Install the DVD Drive
1. Push the DVD drive into the chassis until the release tab on the rear of the
DVD drive engages the chassis with an audible click (see FIGURE: Removing
the DVD Drive on page 92 [4]).
2. Reconnect the DVD drive cable [2].
3. Return the server to operation.
a. Install the server top cover.
See “Install the Server Top Cover” on page 145.
b. Close the fan door.
c. Return the server to the normal rack position.
See “Return the Server to the Normal Rack Position” on page 148.
d. Reconnect the power cords to the server power supplies and reconnect the
data cables.
See “Reconnect Data Cables and Power Cords” on page 149.
e. Power on the server.
See “Power On the Server” on page 150.
Verify that the Power/OK status indicator is steady on.
Related Information
■ “Remove the DVD Drive” on page 91
To Next Page
Loading...
