Sun Oracle Sun Server X4-2 - Page 223

BIOS Setup Utility Menu Options 209
TPM Support Disabled/Enabled Enabled Enable or disable TPM support.
Only UEFI BIOS implements this
setup option. If disabled, the OS
will not show TPM. Reset of the
platform is required.
TPM State Disabled/Enabled Disabled Displays whether TPM Support
is enabled.
Current TPM Status
Information (R/O)
If TPM Support is disabled,
Current TPM Status displays
“TPM SUPPORT OFF.”
If TPM Support is enabled,
Current TPM Status displays:
• TPM Enabled Status:
• TPM Active Status:
• TPM Owner Status:
NETWORK STACK Configure network stack
settings.
Network Stack Disabled/Enabled Enabled Enable or disable the UEFI
network stack.
Ipv4 PXE Support Disabled/Enabled Enabled Enable or disable IPv4 PXE Boot
support. If disable, the IPv4 Boot
Option will not be created.
Ipv6 PXE Support Disabled/Enabled Disabled Enable or disable IPv6 PXE Boot
support. If disable, the IPv6 Boot
Option will not be created.
BMC NETWORK Configure Baseboard
Management Controller (BMC)
network parameters.
BMC Network: Current
Active Management Port
(R/O)
Active management port settings
are displayed.
Refresh Refresh current BMC network
information with the latest
information from the service
processor.
Active Management Port NETMGT/
NET0/
NET1/
NET2/
NET3
Change the management port
that is currently active.
TABLE: BIOS Advanced Menu Options (Continued)
Setup Options Options Defaults Description