40 Sun Server X4-2 Service Manual • May 2014
1. To prevent the rack from tipping forward when the server is extended, extend
all rack anti-tilt devices.
Caution – To reduce the risk of personal injury, stabilize the expansion rack cabinet
and extend all anti-tilt devices before extending the server from the rack.
For instructions for stabilizing the rack, see the Sun Server X4-2 Installation Guide,
“Stabilize the Rack for Installation” on page 43.
2. Verify that no cables will be damaged or will interfere when the server is
extended.
Although the cable management arm (CMA) that is supplied with the server is
hinged to accommodate extending the server, you should ensure that all cables
and cords are capable of extending.
3. To release the slide-rails locks, pull down on the flip-down handles, which are
located on the sides of the server front panel (see FIGURE: Slide-Rail Release
Latches on page 41 [callout 1]).
Note – The slide-rail locks are located behind the flip-down handles on the front of
the server. The slide-rail locks are released when the flip-down handles are pulled
down.
The server is now in the extended maintenance position.
To Next Page
Loading...
