#7,FT;
This function returns file system on SD-card in the format #7,FT,x;.where x denotes -1: no SD-card,
1: FAT16, 2: FAT32, 3: FAT12.
#7,IM,x;
This function sets mode of the interface in the format #7,IM,x; where x denotes 0: START_STOP,
1: SIMPLE, 2 ADVANCED. Function returns the following sequence of characters: #7,IM;
#7,IM;
This function returns mode of the interface in the format #7,IM,x;
#7,KL,x;
This function locks ( x = 1 ) or unlocks ( x = 0 ) keyboard and returns the following sequence
of characters: #7,KL;
#7,KL;
This function returns the states of keyboard lock in the format #7,KL,x;
#7,LA;
This function returns current language in the format: #7,LA,xx; where xx is language codes:
GE (German), EN (English), IT (Italian), PL (Polish), RU (Russian), HU (Hungarian), TU (Turkish),
NL (Flemish), FR (French), SP (Spanish).
#7,LB;
This function returns the name of last logger in format #7,LB,logger_name;
#7,LS,setup_name;
This function loads setup and writes settings into EEPROM. The selected file must exist.
The function returns #7,LS;
#7,LW;
This function returns the name of last wave file in format #7,LW,wave_file_name;
#7,MC;
This function returns microphone compensation in the format #7,MC,x;
#7,MC,x;
This function enables ( x = 1 ) or disables ( x = 0 ) the microphone compensation and returns
the following sequence of characters: #7,MC;
#7,MG,p1,p2,p3,p4,p5,p6,p7,p8,p9,p10,p11,p12,p13,p14,p15,p16,p17,p18,p19,p20;
Set GPS marker. All parameters are optional.
where:
p1 – signal quality,
p1 = 0 - no signal,
p1 = 1 - GPS fix,
p2 – Seconds part of time,
p3 – Minutes part of time,
p4 – Hours part of time,
To Next Page
Loading...
