Svantek SVAN 971 - Configuring Measurement Parameters; General Settings

SVAN 971 User Manual
29
5 CONFIGURING MEASUREMENT PARAMETERS – Measurement
The Measurement section combines elements related to
measurement parameters configuration. To open the
Measurement section, press the <Menu> key, select the
Measurement position and press <Enter>.
<ENT>
The content of the Measurement list is different for
different Interface modes (Simple and Advanced) and
Measurement Function. Some example windows for
Advanced and Simple modes are presented.
The Measurement section contains following positions:
General Set allowing to set up general measurement parameters;
Meas. Trig. allowing to configure the measurement trigger. This position appears only in
Advanced interface mode;
Profiles allowing to set up parameters specific for the profile. This position disappears in
the Dosimeter function;
Profile 1 (2,3) allowing to set up parameters specific for profiles in the Dosimeter function.
These positions appear only in the Dosimeter function instead of Profiles;
Alarm allowing to programme the alarm function. This position appears only in the
Dosimeter function and the Advanced interface mode;
Logging allowing to configure the logging function;
Spectrum allowing to set up spectrum parameters. This position becomes available only in
1/1 Oct. and 1/3 Oct. functions;
Range allowing to set up the required measurement range;
Comp. Filter allowing to switch on the required compensation filter. This position appears only
in Advanced interface mode;
Stat. Lev. allowing to define 10 statistical levels;
Exp. Time allowing to set up the exposure time for dose measurements. This position
appears only in the Dosimeter function and Advanced interface mode;
Timer allowing to programme the internal timer. This position appears only in
Advanced interface mode.
5.1 SETTING UP GENERAL MEASUREMENT PARAMETERS - GENERAL SETTINGS
The General Set list allows to programme general
measurement parameters: delay of the measurement
start of (Start Delay), synchronisation with the
instrument’s RTC (Start Sync.), integration
period/measurement run time (Integr. Per), repetition of
measurement cycles (Rep. Cycles), LEQ detector type
(LEQ Integr.) and duration of day periods (Day Time L.).
<ENT>