Svantek SVAN 971 - Control Setting Codes

SVAN 971 User Manual – Appendixes
113
where:
FILE_TYPE type of the file
2 - setup file,
4 - current settings file,
FILE_LENGTH length of the file in bytes,
DATA binary content of the file.
A.10 CONTROL SETTING CODES
The control setting codes used in the SVAN 971 instrument (the internal software revision 1.10.2) are given
in the table below.
Table A.1. Control setting codes
Group name
Group
code
Code description
Unit type
U
U971 (read only)
Serial number
N
Nxxxx (read only)
Software version
W
Wyyy yyy - revision number (read only)
Calibration factor
Q
Qnnnn:c nnnn - real number with the value
of the calibration factor (-99.9  99.9)
c: 0 - left channel, 1 - right channel
Measurement function
M
M1 - LEVEL METER
M2 - 1/1 OCTAVE analyser
M3 - 1/3 OCTAVE analyser
M4 - DOSE METER
M7 - RUNNING LEQ
Range
R
R1 - LOW
R2 - HIGH
Filter type in profile n
F
F1:n - Z filter for profile n
F2:n - A filter for profile n
F3:n - C filter for profile n
SLM, 1/1OCTAVE, 1/3OCTAVE, RUNNING LEQ
functions:
n: 1, 2, 3 – Profile Number: 1, 2 or 3
DOSE functions:
n: 4, 5, 6 – Profile Number: 1, 2 or 3
Peak Filter type in profile n
J
J1:n - Z filter for profile n
J2:n - A filter for profile n
J3:n - C filter for profile n
SLM, 1/1OCTAVE, 1/3OCTAVE, RUNNING LEQ
functions:
n: 1, 2, 3 – Profile Number: 1, 2 or 3
DOSE functions:
n: 4, 5, 6 – Profile Number: 1, 2 or 3