Press during embroidery (during machine stop) and you will be asked, “Do you want to cancel DATA SET?”
as shown in [Fig.6.2-1]. Press to stop the embroidery and the main function menu will change to the menu
before embroidery. Press not to end embroidery - you will see EMB CALL, the same as before embroidery
as shown in [Fig.6.2-2]. Deleting and selecting of the design called as well as selecting other designs will not be
available. But you can output the design. This is a new function, which enables you to copy designs during embroidery
- you don’t have to wait until the embroidery is finished to copy the design.
Use of the function is the same as before embroidery.
6.2 EMB CALL
[Fig.6.2-1] [Fig.6.2-2]
To Next Page
Loading...
