[Fig.6.0-1] appears when you stop the machine during embroidery. The menu structure is basically the same as the
menus before you start the embroidery. The difference is that “Ready”, “Repeat Work”, and “Edit” are replaced by
“Float”, “Frame”, and “S-Code” in the main function menu. Few functions are also limited in the setting menu as well.
Although you must have done settings before the embroidery, you might want to change the setting for better work.
Now, let’s look at the functions during embroidery (machine stop).
The following describes only those menus that are different from the ones before the embroidery - “EMB CALL”,
“SETTING”, “FLOAT”, “FRAME”, and “S-CODE”.
6
Function Menu during Embroidery
[Fig.6.0-1]
[NOTE]
To perform floating at the start using menus during embroidery, press STOP and you will go to the function
menus during embroidery.
To Next Page
Loading...
Need help?
General
