TURN ON THE MAIN POWER
IS THE OPERATIONG SYSTEM IN MEMORY?
IS LEFT OR RIGHT START BUTTON PRESSED?
INSTALL OPERATING SYSTEM
ARE THERE DESIGNS IN MEMORY?
CALL DESIGN
SELECT NEEDLE BAR
SET-UP PARAMETERS FOR OPERATION
DO YOU WANT REPETITION?
DO YOU WANT AUXILIARY WORK (GAUGE, ETC.)
SET WORK POSITION
DO YOU WANT FRAME OFFSET?
PUSH BAR SWITCH TO START
REPETITION
AUXILIARY WORK
SET-UP FRAME OFFSET
READ DESIGN FROM DISK OR USB
ARE THERE PREVIOUSLY WORKED DESIGNS?
AUTOMATIC READ IN DESIGN
AUTOMATIC READ IN OF SETTING
CHANGE SETTING?
NO
NO
NO
NO
NO
NO
NO
YES
YES
YES
YES
YES
YES
YES
YES
2.2 Basic procedures
To Next Page
Loading...
