5.12.2 Stitch divide
It divides a design in the desired part and saves them separately. You can divide a design by color or stitch.
[Fig.5.12.2-1] shows selection of Design Divide in the screen [Fig.5.12.0-1]. The design on the left screen shows a
design called by EMB CALL. The right screen will show the part divided from the design on the left.
STITCH : It divides a design by the number of stitches.
Add colors : It leaves one color on the left and sends the rest of the colors to the right.
(The same function as in 5.10.4 Fastview)
Remove colors : This function is available only after selecting ＋COLOR and offers the opposite function
from ＋COLOR. Press －COLOR and the colors divided from the original design will
be merged back again at one color at a time.
(The same function as in 5.10.4 Fastview.)
SELECT : It saves the two divided designs in the memory.
[Fig.5.12.2-1]
To Next Page
Loading...
Need help?
General
