Symmetricom TimeSource 3100 User Guide

097-72020-01 Revision K – December 2005 TimeSource User’s Guide 117
Chapter 4 TL1 Reference
Commands
SPAN-a ENSEMBLER=b
(See Notes 7, 8)
b = ALW Span is ensembled
b = INH Span is not ensembled
SSM=b (See Note
8)
b = ALW SSM qualifies span input
b = INH SSM does not qualify span input
SSMCHANNEL=b b = 4 Uses Sa4 bit
b = 5 Uses Sa5 bit
b = 6 Uses Sa6 bit
b = 7 Uses Sa7 bit
b = 8 Uses Sa8 bit
E1-a ALMOUT=b b = AIS Output is AIS during alarm
b =
SQUELCH
Output is squelched during alarm
b = SSM Outputs are at “SSUT” quality level during
holdover alarm (SSM requires CAS4 or
CCS4 output framing)
FRAMING=b b=CAS Output framing is CAS
b=CAS4 Output framing is CAS4
b=CCS Output framing is CCS
b=CCS4 Output framing is CCS4
b=NONE Output framing is NONE (analog) (If
ALMOUT is SQUELCH, then signal turns off
during Holdover alarm. Any other ALMOUT
option does not affect output during alarm)

Symmetricom TimeSource 3100 Specifications

General

Brand	Symmetricom
Model	TimeSource 3100
Category	GPS
Language	English