2-8
1345678
2
ANALYSIS
INTRODUCTION
pocH-100
i
Revised February 2011
Incorrect analysis results
All performance data cited in this manual were
generated using specimens in EDTA anticoagulant.
Results may differ using other anticoagulants.
Note
The sample ID can be set up to 15 characters. If a sam-
ple‘s ID is set to „ 0 “, the result for this sample will not
be stored.
• When using micro tubes, place them in the cor-
rect adapter and make sure the cap is removed.
• When a sample tube with a cap is used, manually
remove the cap before analysis.
The pipette might be permanently damaged, if
the cap was not removed.
*
1
.
Do not open the sample position while aspi-
rating!
Important
To Next Page
Loading...
