SYSMEX pocH-100i - 2.1.5. WB Analysis (Close Piercer)

2-5
ANALYSIS
1 345678
2
1
2
3
4a
4b
5
6
7
8
9
10
11
ANALYSIS
INTRODUCTION
pocH-100
i
Revised February 2011
2.1. ANALYSIS
or
2.1.5. a) Analysis in whole blood (WB) mode (for close piercer)
• Check blood with added EDTA anticoagulant, aspirated sample volume ~15μL.
• Required sample volume: >1mL for the ø 13mm tube, > 500μL for the micro tube.
Gently mix the sample. Analyze with or with-
out pierceable cap.
The analysis starts. The results are displayed
within approx. 90-125 seconds and are
stored automatically.
Insert adapter.
Mix the sample. The analysis starts.
Insert sample tube and close the door. (
*
1
)
Insert the sample tube and close
the door.
Press "Sample ID".
Enter the ID manually or by barcode reader
and press "Ent.".
Press "Sample ID".
Enter the ID and press "Ent.".
Press "RUN".
Press "RUN".
Analysis results are automatically printed/
sent to host computer according to
settings(from page 5-2).
Analysis results are automatical-
ly printed according to settings.
Insert the correct adapter.
Open sample position.
Open sample position.
Enter the operator ID and press "Ent.".
Select a operator ID.
Press the -button or press "Operator".
Select a operator ID.
Enter the operator ID and press
"Ent.".
Press the -button or press "Op-
erator".