5-6
1234678
5
pocH-100
i
Revised June 2008
SETTINGS & CALIBRATION
INTRODUCTION
Press "Menu" > "Settings" > "Host Output".
The underscored items are factory settings.
5.1.2.6. Host settings
To set data output to host computer.
Parameter Setting
Connect
Disable / Serial / LAN
Automatic Output
Enable / Disable
Format
pocH / KX-21N / ASTM / K-1000
Transfer Rate
1200 bps / 2400 bps / 4800 bps / 9600 bps / 19200 bps
Data Length
7 bits / 8 bits
Stop bit
1 bit / 2 bits
Parity
Even / Odd / Disable
Protocol
Class A / Class B
Transfer Interval
0 s / 2 s / 3 s / 5 s / 7 s / 10 s / 15 s
RTS/CTS
Enable / Disable
ID Pad.
0 pad / SpacePad.
RDW
RDW-SD / RDW-CV
ASTM Rev.
1381-95 / 1381-02
Press "Menu" > "Settings" >
"Host Output".
Note
To Next Page
Loading...
