2-7
ANALYSIS
1 345678
2
1
2
10
11
3
4 7
85
6 9
ANALYSIS
INTRODUCTION
pocH-100
i
Revised February 2011
2.1. ANALYSIS
2.1.5. b) Analysis in whole blood (WB) mode (for open pipette)
• Check blood with added EDTA anticoagulant, aspirated sample volume ~15μL.
• Required sample volume: >100μL for the ø 13mm tube, > 50μL for the micro tube.
The analysis starts. The results are displayed
within approx. 90-125 seconds and are
stored automatically.
The analysis starts.
Set the spacer to an adapter.
Set the spacer to an adapter.
Gently mix the sample.
Mix the sample.
Remove the cap.
Remove the cap.
Insert sample tube and close the door. (
*
1)
Insert the sample tube and close
the door.
Press "Sample ID".
Enter the ID manually or by barcode reader
and press "Ent.".
Press "Sample ID".
Enter the ID and press "Ent.".
Press "RUN".
Press "RUN".
Analysis results are automatically printed/
sent to host computer according to settings
(from page 5-2).
Analysis results are automatical-
ly printed according to settings.
Open sample position.
The sample tube caps have to be removed
before measurement.
Open sample position.
Insert adapter.
Insert the correct adapter.
To Next Page
Loading...
