SYSMEX pocH-100i - 4. Cleaning & Maintenance

4-1
123 5678
4
CLEANING & MAINTENANCE
INTRODUCTION
pocH-100
i
Revised February 2011
4. CLEANING & MAINTENANCE : CONTENTS
4.1. CLEANING 4-2
4.1.1. Clean instrument surface 4-2
4.1.2. Check instrument status 4-2
4.1.3. Shutdown 4-3
4.1.4. Clean transducer 4-4
4.1.5. Clean waste chamber 4-5
4.1.6. Clean the sample tube adapter 4-6
4.1.7. Perform auto rinse 4-6
4.1.8. Remove clog from transducer aperture 4-7
4.1.9. Dispose waste fluid 4-8
4.1.10. Drain reagents 4-9
4.1.11. Calibrate LCD 4-10
4.1.12. Replace thermal printer paper 4-11
4.1.13. Replace reagent 4-12
4.2. TECHNICAL MAINTENANCE-Qualified personnel only! 4-13
4.2.1. Clean aperture of TD chamber 4-13
4.2.2. System fuse replacement 4-15