SYSMEX pocH-100i - 4.1.8. Remove Transducer Aperture Clog

4-7
123 5678
4
1
pocH-100
i
Revised June 2008
CLEANING & MAINTENANCE
INTRODUCTION
4.1. CLEANING
4.1.8. Remove clog from transducer aperture
Ifan"ApertureClog"erroroccurs,theclogmustberemoved.
Evenifthemessage"ApertureClog"isnotdisplayed,automaticclogremovalcanbeexecutedbypressing"Menu","Maint."andthen"ClogRemoval".
Press "Execute";automatic clogremoval
starts.(
*
1)
Note
*
1
. To return to the main screen with-
out performing automatic clog re-
moval,press"Cancel".
As needed
Press "Execute".