Systec DB-45 - Page 112

V/D S ERIES
E LECTRICAL ASSEMBLIES
4-2 Revision: 2.1
4.3.2 D-23 ........................................................................................................... 24
4.4 Replacing or upgrading the printer........................................ 25
Diagrams
Fig. 1: Front of the E-Box V/D-40 – 55 ................................................. 3
Fig. 2: Underside of the E-Box V-40 – 55, D-45 ................................... 4
Fig. 3: Front of the E-Box (V/D 65 l – 200 l) ......................................... 5
Fig. 4: Underside of the E-Box (V/D 65 l – 200 l) ................................. 6
Fig. 5: Top of the analogue circuit board AS1002 ................................ 7
Fig. 6: Underside of the analogue circuit board AS1002 ...................... 7
Fig. 7: AES1002 extension board ........................................................ 8
Fig. 8: Digital circuit board DS1002 ..................................................... 9
Fig. 9: Motor control board for radial fan ............................................ 10
Fig. 10: Special circuit board for motor control on the radial fan
(D-23) ...................................................................................... 11
Fig. 11: ACT1 circuit board, top and underside .................................... 12
Fig. 12: SD card circuit board .............................................................. 13
Fig. 13: Analogue circuit board LM1085: Position in the circuit
diagram ................................................................................... 14
Fig. 14: Power transistors VNP5N07: Position in the circuit diagram ... 14
Fig. 15: Power supply .......................................................................... 15
Fig. 16: Solid state relay: Position in the circuit diagram ...................... 16
Fig. 17: Fuse block: Position in the circuit diagram .............................. 17
Fig. 18: Front of the E-Box (D-23) ........................................................ 18
Fig. 19: Underside of the E-Box (D-23) ................................................ 19
Fig. 20: Analogue circuit board on the D-23......................................... 20
Fig. 21: Digital circuit board on the D-23 .............................................. 21
Fig. 22: Power supply circuit board on the D-23 .................................. 22
Fig. 23: Relay board for motor control on the D-23 .............................. 23
Fig. 24: Fuse block: Position in the circuit diagram .............................. 23
Fig. 25: Opening the cover ................................................................... 25
Fig. 26: Loosening the screws ............................................................. 25
Fig. 27: Connecting the printer to the E-Box ........................................ 26