V/D
S
ERIES
C
OMMISSIONING
2-18 Revision: 2.1
2.10 Instructing the operating personnel
Explain the functions on the device to the operating personnel
and point out the associated risks, particularly when sterilising
liquids in open and closed containers.
Inform the operating personnel about the following functions and safety
aspects associated with the operation of the device.
2.10.1 Supply connections
The operating personnel must open the supply connections before starting
work and must close them again after finishing (see operating manual,
chapter 4, “Operation”).
2.10.2 Loading the device
A detailed description of loading and the program cycle can be found in
the operating manual (see chapter 4, “Operation”).
2.10.3 Using menus
A detailed description of using the menus can be found in the operating
manual (see chapter 4, “Operation”).
2.10.4 Recognising error messages
An error message can be recognised as follows:
− The display shows an error message.
− The red ERROR LED lights up.
− The (optional) printer records the error message.
Proceed as follows to acknowledge the alarm:
• Press the Quit button.
• Enter the access code for service level 1 (1000).
• Press the Set button to confirm.
More detailed information on fault messages and how to rectify them can
be found in the operating manual (see chapter 8, “Troubleshooting”).
2.10.5 Documentation software (optional)
• Install the Systec Autoclave Documentation Software (SADS) on the
customer PC.
• Connect the PC to the device via the interface cable supplied.
• For configuration, use the configuration program contained in the
documentation software (see SADS installation manual).
To Next Page
Loading...
