Systec DB-45 - Performing a Test Run; Setting Parameters; Switching the Device on and off

V/D S ERIES
C OMMISSIONING
Revision: 2.1 2-17
2.7 Switching the device on and off
The device has a main switch, which can be used to switch it on and off.
Note
Always switch off the device at the main switch when not in use.
2.8 Performing a test run
• Select a sterilisation program that takes the built-in options into
account.
• Make a test run to check the functionality of the device and to check for
leaks.
2.9 Setting parameters
• If necessary, set different parameters as required by the customer (see
chapter 8, “Parameters”).
To do this, use the following access level and codes:
Access level Access code
1 1000
2 0011
3 0022
4 0198
Do not give any
c
odes for access levels to unauthorised
persons!
The code for access level 4 is exclusively reserved for service
technicians and must never be given to the operator.
• Use the operating manual to explain to the customer how parameters
can be changed.
Detailed information can be found in the operating manual (see operating
manual, chapter 4, “Operation”).